Mechanical Specifications - Western Digital Ultrastar Data60 User Manual

User Guide
Table 2: Electrical Specifications
Specification
Max Power Consumption
Typical Power Consumption
PSU Connector Type
Inrush Current Maximum (per
Caution: The Ultrastar Data60 can only be plugged into high line (200 - 240 VAC) power. If
the unit is plugged into low line (110-127 VAC), the PSU will report a "Critical" state when status
pages are queried using SES. In this case, the enclosure will power up, but the drives will not.
The enclosure will remain in low-power mode.
1.6 Mechanical Specifications
Table 3: Mechanical Specifications
Specification
Dimensions
Length without CMA
Required Rack Width
Required Rack Depth
Rack Units (U)
2. Max and typical power consumption values represent the output power to the system. Input power will vary depending
on the PSU efficiency and load sharing between PSUs.
2
Input Voltage
PSU Efficiency
AC line inrush current shall not exceed 40A peak, for up to
PSU) one-quarter of the AC cycle after which, the input current
should be no more than the specified maximum input current.
Non-Operational
Shock 10G, 0 - peak,11ms half sine;
3 positive and 3 negative
pulses in each axis Shock
Vibration 0.75G, 0 - peak swept sine;
5 -500Hz; 1 complete sweep
@ 1/2 octave per minute
Weight
447mm x 890mm x 175mm / 17.67in. x 35.04in. x 6.89in.
nominal hole spacing. See EIA-310 Rack Standard
900mm (35.43in.) usable rack space, frame to frame
~1250W
~1000W
200 - 240 VAC
80 PLUS Platinum
5G, 0 - peak, 11ms half sine; 3 positive
minimum 6 seconds between shocks
79.4 kg. / 175 lbs.
712 mm / 28.03in.
450mm (17.72in.) with 465mm (18.31in.) ± 1.5mm
4U

1.6 Mechanical Specifications

Value
C14
Operational
and 3 negative pulses in each axis-
to allow for write/read recovery
0.10G,0 - peak swept sine; 5
-500Hz; 1 complete sweep
@ 1/2octave per minute
1. Overview
5