Western Digital Ultrastar Data60 User Manual page 124

User Guide
Figure 117: Installing a 3.5in HDD Assembly
d. Pinch the latch release and carefully press downward to seat the 3.5in HDD Assembly the
rest of the way.
Step 28 : Install each drive in the place it was removed from by following the labels or marks that were
added earlier.
Step 29 : Install the CMA(s).
a. Orient the CMA so that the elbow is on the left hand side.
b. Attach all three of the connectors to the brackets on the rails. There should be one at the
elbow side and two at the other end.
Note: The CMA has two arms, labeled "upper" and "lower." The lower arm should
have the elbow on the left side and be installed first; the upper arm should have
the elbow on the right side and be installed last.
3. Support
3.8 Rails Replacement
112