Mechanical Specifications; Performance Specifications - Western Digital Ultrastar Data60 Installation Manual

Installation Guide
Inrush Current Maximum (per
Caution:
the unit is plugged into low line (110-127 VAC), the PSU will report a "Critical" state when status
pages are queried using SES. In this case, the enclosure will power up, but the drives will not.
The enclosure will remain in low-power mode.
1.5 Mechanical Specifications
Table 4: Mechanical Specifications
Specification
Enclosure Dimensions
Length of Enclosure
w/o CMA
Required Rack Width
Required Rack Depth
Rack Units (U)
Vertical Rack Rail
1.6 Performance Specifications
3. Listed weight is for a dual-IOM enclosure, fully populated with 60 drives. It does not include the CMA, cable tray,
accessories, or packaging/shipping materials.
Specification
PSU Efficiency
AC line inrush current shall not exceed 40A peak, for up to
PSU)
should be no more than the specified maximum input current.
The Ultrastar Data60 can only be plugged into high line (200-240 VAC) power. If
Non-Operational
Shock 10G, 0 - peak,11ms half sine;
3 positive and 3 negative
pulses in each axis Shock
Vibration 0.75G, 0 - peak swept sine;
5 -500Hz; 1 complete sweep
@ 1/2 octave per minute
Weight
450 mm (17.72 in.) minimum width, with 465 mm (18.31 in.) ±
1.5 mm nominal hole spacing. See EIA-310 Rack Standard.
900mm (35.43in.) usable rack space, frame to frame
Spacing
80 PLUS Platinum
one-quarter of the AC cycle after which, the input current
79.4 kg. / 175 lbs.
W: 447 mm x L: 890 mm x H: 175 mm
/ W: 17.67 in. x L: 35.04 in. x H: 6.89 in.
712 mm / 28.03in.
4U
609.6 - 812.8 mm / 24 - 32 in.

1.5 Mechanical Specifications

Value
Operational
5G, 0 - peak, 11ms half sine;
3 positive and 3 negative
pulses in each axis- minimum
6 seconds between shocks to
allow for write/read recovery
0.10G, 0 - peak swept sine;
5 -500Hz; 1 complete sweep
@ 1/2 octave per minute
3
1. Overview
5