Western Digital Ultrastar Data60 User Manual page 145

User Guide
Figure 148: Inner Rail Attachment
c. Slide the inner rail toward the rear of the chassis to lock it in place. There will be an audible
click and the mounting pegs will cover the front part of the keyhole.
Figure 149: Slide Inner Rail
d.
Install the two special low-profile M4 x 3.2mm Philips screws provided to secure the inner rail
to the chassis.
e. Follow these steps for the second inner rail on the opposite side of the enclosure.
Step 27 : Secure the Cable Tray onto the enclosure using the included M3 x 8mm T10 Torx screws and the
Long T10 Torx Screwdriver. These screws should be tightened to .33-.56 Nm / 3-5 in-lbf using a
Long T10 Torx Screwdriver.
Caution: When installing the inner rail onto the chassis, make sure to only use
the special Low-Profile M4 x 3.2mm Philips screws provided in the accessory
kit with the CMA. These screws should be tightened to .90-1.12 Nm / 8-10 in-
lbf using a # 2 Philips Screwdriver. These screws are specially designed for this
purpose. Using unapproved screws could cause damage to the slides inside
the rail.
3. Support
3.9 Chassis Replacement
133