Chassis Replacement - Western Digital Ultrastar Data60 User Manual

User Guide
Figure 126: Cinching Cable Retention Clip
g. If the Ultrastar Data60 is being installed in a rack and will subsequently be transported inside
that rack, it is important to use the included cable tie to wrap the CMA bundle to ensure it
does not get damaged during transport. If the Ultrastar Data60 is instead being installed
where it will operated, skip this step.
h. Close all of the baskets.
i. Reconnect the CMA at the elbow to connector A.
Step 32 : Test for binding in the extension of the arm by gently pulling the enclosure out of the rack,
ensuring the cables extend properly and that the system doesn't bind at all. If it does, examine
the point at which the binding occurred and adjust the seating of cables in the baskets, check
the connections to the rails, and examine the joints of the arm to ensure that they are all
functioning properly.
Step 33 : Make sure the CMA(s) is in operational position by folding the arm(s) in toward the enclosure and
attaching the elbow end(s) to the connector(s) attached to the rail. Verify that all of the cabling is
in functional order and does not bind or catch.
3.9 Chassis Replacement
Replacement Requirements
Personnal Required
Avg. Replacement Time
Max Replacement Time
Tool
Long T15 Torx Screwdriver
# 2 Philips Screwdriver
T30 Torx Screwdriver
Long T10 Torx Screwdriver
3. Support

3.9 Chassis Replacement

3
2 hr.
2 hr.
Required vs. Recommended
Required
Required
Required
Required
119