User Guide
Figure 80: Chassis Handle Operation
Step 19 : Perform this same action two more times without the drives loaded to make sure the rail kits are
installed properly.
Step 20 : Install the 3.5in HDD Assembly.
a. Ensure that the enclosure has been pulled out of the rack until the rail latches engage.
b. Find the LED pointer on the top of the drive carrier. This pointer should point toward the
front of the unit as shown in the following image.
Note: The 2.5in SSD Assembly is installed in the same manner as the 3.5in HDD
Assembly. For instructions on assembling the 2.5in SSD Assembly, see Operating
the 2.5" Drive Carrier (page
).
3. Support
3.7 CMA Replacement
87