Western Digital Ultrastar Data60 User Manual page 178

User Guide
Step 4 : Press Enter.
The firmware begins loading onto the IOMs. The upgrade can take up to 20 minutes to
complete.
Step 5 : Once the download is complete, type:
sg_ses_microcode <dev> -m 0xf
Step 6 : Press Enter.
The IOMs will reset. This process can take up to 5 minutes to activate.
Important:
Due to the firmware image being a .tar.gz file, the enclosure has to unpack and
load the firmware onto the respective ICs which may take up to 15 minutes.
Once the sg_ses_microcode command is issued wait 20 minutes to ensure the
enclosure has time to perform this process. To check the status of this process,
use the Redfish out-of-band management to make a GET request to the following
target:
curl -G -k -u admin:admin -H "Content-type: application/
json" https://<ip address>/redfish/v1/UpdateService/Actions/
UpdateService.SimpleUpdate/Status
Note:
Execute the command until you see the following result:
{"ErrorCode":0,"StatusCode":2,"Description":"FW update completed.
Waiting for activation.","EstimatedRemainingMinutes":0}
Attention: If the OOBM is not being used, query Page Eh by executing the
following command
sg_ses <dev> -p 0xe
the output may be inaccurate, please ignore and issue the command again. The
string to observe for download microcode status is "Complete, no error, start
after hard reset or power cycle [0x11]" before proceeding to the activate step.
Example output:
sg_ses <dev> -p 0xe
HGST H4060-J 2040
Download microcode status diagnostic page:
number of secondary subenclosures: 0
generation code: 0x0
subenclosure identifier: 0 [primary]
download microcode status: Complete, no error, start after
hard reset or power cycle [0x11]
download microcode additional status: 0x0
download microcode maximum size: 1703914 bytes
download microcode expected buffer id: 0x0
download microcode expected buffer id offset: 0
4.3 Firmware Upgrade
. The first time this command is issued,
4. Management
166