Western Digital Ultrastar Data60 User Manual page 191

User Guide
POST /redfish/v1/UpdateService/Actions/UpdateService.SimpleUpdate HTTP/1.1
Content-Type: application/json;charset=utf-8
Content-Length: <computed length>
OData-Version: 4.0
Authorization: Basic userid:password
a. In the body of the POST, list the
parameter to the file location of the bin file.
Linux Example:
{"ImageURI": "tftp://<tftp IP address>/HGST_Ultrastar-DATA60-DATA102-
Server60-8_SEP_bundle_3000-058_3.0.27.tar.gz"}
Windows Example:
{\"ImageURI\":\"https://<https IP address>/HGST_Ultrastar-DATA60-DATA102-
Server60-8_SEP_bundle_3000-058_3.0.27.tar.gz\"}
Step 4 : To check the status of this process, make a GET request to the following target:
curl -G -k -u admin:admin -H "Content-type: application/json" https://<IP
address>/redfish/v1/UpdateService/Actions/UpdateService.SimpleUpdate/Status
a. Execute the command until you see the following result:
{
}
Step 5 : To activate the firmware, send a POST request:
• For an automatic activation, send the POST request to the
the
curl -X POST -k -u admin:admin -H "Content-type: application/
json" https://<IP address>/redfish/v1/UpdateService/Actions/
UpdateService.FWActivate
• For a non-automatic activation, reset the IOMs manually by sending sequential POST
requests to the
Note: TFTP and HTTPS are supported.
Note: This command may need to be issued multiple times until it reports a
completed status. This should be done before completing the remainder of the
procedure.
"ErrorCode":0,
"StatusCode":2,
"Description":"FW update completed. Waiting for activation.",
"EstimatedRemainingMinutes":0
UpdateService.FWActivate
Note: This command will perform a rolling reset of the IOMs.
object using the
Chassis
4.4 OOBM Management Overview
as the data parameter, and set the value of this
ImageURI
command:
Chassis.Reset
4. Management
object using
UpdateService
command:
179