User Guide
Figure 204: Chassis Handle Operation
Step 2 : Locate the area that the new drives will be installed into. When adding SSDs, the drives slots
may already contain a drive. The drive will have to be removed and relocated before installing
the HDD.
Step 3 : Follow the requirements for partial populations listed in
214).
Step 4 : Install the 3.5in HDD Assembly.
a. Ensure that the enclosure has been pulled out of the rack until the rail latches engage.
b. Find the LED pointer on the top of the drive carrier. This pointer should point toward the
front of the unit as shown in the following image.
Note: The 2.5in SSD Assembly is installed in the same manner as the 3.5in HDD
Assembly. For instructions on assembling the 2.5in SSD Assembly, see Operating
the 2.5" Drive Carrier (page
4.8 Partially Populated Enclosures
Partial Population Configurations (page
).
4. Management
218