Western Digital Ultrastar Data60 User Manual page 212

Hide thumbs Also See for Ultrastar Data60:
Table of Contents

Advertisement

User Guide
Step 4 : Build the sg_senddiag command using the information recorded in earlier steps.
a. Use the example of the sg_senddiag command shown in the image above to complete the
specific sg_senddiag command for IOM A. Replace letters a through d with the information
recorded in previous steps.
sg_senddiag Command
sg_senddiag <a> --pf --raw=04,00,00,90,<b>,<c>,00,00,<d>
a. SCSI device (<dev>): device associated with IOM A
b. Disable Zoning: 60
c. Zoning Configuration: configuration 00
d. IOM SAS Address: SAS Address associated with IOM A
b. Use the example of the sg_senddiag command shown in the image above to complete the
specific sg_senddiag command for IOM B. Replace letters a through d with the information
recorded in previous steps.
sg_senddiag Command
sg_senddiag <a> --pf --raw=04,00,00,90,<b>,<c>,00,00,<d>
a. SCSI device (<dev>): device associated with IOM B
b. Disable Zoning: 60
c. Zoning Configuration: configuration 00
d. IOM SAS Address: SAS Address associated with IOM B
c. The following are examples of completed sg_senddiag commands for IOM A and B.
• IOM A: sg_senddiag 3 --pf --raw=04,00,00,90,60,00,00,00,50,00,CC,AB,03,00,00,3C
transport: Serial Attached SCSI Protocol (SPL-4)
0x5000ccab0300003c
Note: For information on preconfigured zoning configurations, see:
Predefined Zoning Configurations (page
Note: A comma should be placed after each bit of data in the IOM SAS
Address that was recorded. For example, if the IOM SAS Address output
was 5000CCAB0300003C, the address that should be added to the
sg_senddiag command should be 50,00,CC,AB,03,00,00,3C.
Note: For information on preconfigured zoning configurations, see:
Predefined Zoning Configurations (page
Note: A comma should be placed after each bit of data in the IOM SAS
Address that was recorded. For example, if the IOM SAS Address output
was 5000CCAB0300007C, the address that should be added to the
sg_senddiag command should be 50,00,CC,AB,03,00,00,7C.
4. Management
180).
180).
4.6 Zoning
200

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

H4060-j

Table of Contents