Western Digital Ultrastar Data60 User Manual page 220

User Guide
Device: /dev/sg2
Dual IOM operation
IOM B
Step 7 : Use the WDDCS Tool's
the zoning configuration of each IOM:
# wddcs /dev/sg1 zone status
wddcs v1.1.8.0
Copyright (c) 2019-2020 Western Digital Corporation or its affiliates
Device: /dev/sg1
Zoning (Disabled)
# wddcs /dev/sg2 zone status
wddcs v1.1.8.0
Copyright (c) 2019-2020 Western Digital Corporation or its affiliates
Device: /dev/sg2
Zoning (Disabled)
R esult: T he zone status of both IOMs should now be
4.6.8.3 Enabling File-Based Zoning Using Windows
This task provides instructions for enabling the file-based zoning feature and configuring zoning using the
file-based method in a Windows operating system environment.
Step 1 : From a command line, use the
connected to the host:
C:\> sg_scan -s | findstr -i H4060
From the output, note the device names for the IOMs (i.e.
SCSI3:0,84,0
SCSI3:1,29,0
Note: Depending on the user's setup, the devices listed in the output may represent
multiple HBAs, connected to multiple IOMs, within multiple enclosures. Further investigation
may be required to determine the correct enclosure for zoning. If further investigation is not
required, proceed to step
Step 2 : To determine the correct enclosure:
a. Use the
C:\> sg_inq SCSI3:0,84,0
standard INQUIRY:
zone status
sg_scan
claimed=0 pdt=dh
claimed=0 pdt=dh
3 (page
utility for each device to determine the serial number of its enclosure:
sg_inq
PQual=0 Device_type=13
[AERC=0] [TrmTsk=0]
SCCS=0 ACC=0 TPGS=0
EncServ=1 MultiP=0 [MChngr=0]
[RelAdr=0] WBus16=0
[SPI: Clocking=0x0 QAS=0
command along with the appropriate SEP handle to verify
.
Disabled
and commands to list the enclosure devices
findstr
SCSIX:X:X:X
HGST H4060-J
HGST H4060-J
209).
RMB=0 LU_CONG=0 version=0x06
NormACA=0 HiSUP=0 Resp_data_format=2
3PC=0 Protect=0 [BQue=0]
[ACKREQQ=0]
Sync=0 [Linked=0] [TranDis=0]
IUS=0]
4. Management
4.6 Zoning
):
2050
2050
[SPC-4]
Addr16=0
CmdQue=1
208