Western Digital Ultrastar Data60 User Manual page 132

User Guide
Cable Ties (for configurations with greater than 10 total cables)
Optional (if using CMA Tray): M3 x 8mm T10 Torx screws
Step 1 : Place the CMA(s) into service position.
a. Unlatch the CMA(s) from the rail at the elbow connector by pressing the blue release button.
Figure 127: Unlatching a CMA Connector
b. Swing the CMA(s) away from the enclosure.
c. The arm(s) should be extended away from the enclosure as shown in the following example.
Tool
Tape Measure
Level
M5 x 12mm T15 Flat Head Torx screws
Included Washers
Low-Profile M4 x 3.2mm Philips
screws (included with rail assembly)
3. Support
3.9 Chassis Replacement
Required vs. Recommended
Recommended
Recommended
Recommended
Required
Required
Required
Required
120