Non-Automatic Firmware Activation In Windows - Western Digital Ultrastar Data60 User Manual

User Guide
Address Weight
-----------------------------------------------------------
0000000077010523 Active/Optimized 001|005|035|000 0 Adapter: Avago
Adapter, SAS3 3008 Fury -StorPo... (B|D|F:
134|000|000) Controller: 46616B65436F6E74726F6C6C6572 (State: Active)
0000000077000430 Active/Optimized 000|004|048|000 0 Adapter: Avago
Adapter, SAS3 3008 Fury -StorPo... (B|D|F:
132|000|000) Controller: 46616B65436F6E74726F6C6C6572 (State: Active)
MPIO Disk97: 02 Paths, Least Blocks, ALUA Not Supported SN:
5000CCA253255E9C
Supported Load Balance Policies: FOO RR RRWS LQD WP LB Path ID
State SCSI
Address Weight
-----------------------------------------------------------
...
4.3.7 Non-Automatic Firmware Activation in Windows
Step 1 : Ensure Windows MPIO can see all paths to the drives.
a. Execute the following command:
C:\mpclaim –v C:\Users\Administrator\Desktop\mpclaim_output.txt
b. Verify that there are two paths to each drive by executing the following command:
C:\more C:\Users\Administrator\Desktop\mpclaim_output.txt
Step 2 : Upgrade the enclosure firmware using sg_ses_microcode by executing the following command:
sg_ses_microcode <dev> -m 0xe -N -b 4096 -I <filename> -vv
Step 3 : Press Enter.
The firmware begins loading onto the IOMs. The upgrade can take up to 20 minutes to
complete.
Note: This should be completed before beginning the firmware upgrade
procedure.
Important: Do not unzip/extract the tar.gz file. Doing so will result in errors during
the firmware upgrade process.
Attention: If the OOBM is not being used, query Page Eh by executing the
following command
sg_ses <device> -p0xe
4. Management
4.3 Firmware Upgrade
.
173