Mechanical Specifications; Performance Specifications - Western Digital Ultrastar Data60 Installation Manual

Installation Guide
Specification
Inrush Current Maximum (per
Caution: The Ultrastar Data60 can only be plugged into highline. If the unit is plugged into
lowline, the PSU will report a "Critical" state when status pages are queried using SES. In this
case, the enclosure will power up, but the drives will not. The enclosure will remain in low-
power mode.
1.5 Mechanical Specifications
Table 4: Mechanical Specifications
Specification
Dimensions
Length without CMA
Required Rack Width
Required Rack Depth
Rack Units (U)
Vertical Rack Rail
1.6 Performance Specifications
Table 5: Performance Specifications
Specification
Number of Drive Slots
Data Transfer Rates
Max Raw Data Storage Capacity
AC line inrush current shall not exceed 40A peak for up to
PSU) one-quarter of the AC cycle, after which, the input current
should be no more than the specified maximum input current.
Non-Operational
Shock 10G, 0 - peak,11ms half sine;
3 positive and 3 negative
pulses in each axis Shock
Vibration 0.75G, 0 - peak swept sine;
5 -500Hz; 1 complete sweep
@ 1/2 octave per minute
Weight
447mm x 890mm x 175mm / 17.67in. x 35.04in. x 6.89in.
nominal hole spacing. See EIA-310 Rack Standard
900mm (35.43in.) usable rack space, frame to frame
Spacing
SAS Ports
5G, 0 - peak, 11ms half sine; 3 positive
minimum 6 seconds between shocks
79.4 kg. / 175 lbs.
712 mm / 28.03in.
450mm (17.72in.) with 465mm (18.31in.) ± 1.5mm
4U
24 in. - 32 in.
12Gbps SAS / 6Gbps SATA
840 TB using 14TB HGST Ultrastar® HC530 drives
12 x Mini-SAS HD ( 6 per IOM)

1.5 Mechanical Specifications

Value
Operational
and 3 negative pulses in each axis-
to allow for write/read recovery
0.10G,0 - peak swept sine; 5
-500Hz; 1 complete sweep
@ 1/2octave per minute
Value
60
1. Overview
5