Dell EMC PowerEdge R7525 Installation And Service Manual page 15

Table 6. Rear view of the system with 2 x 2.5-inch rear drive module (continued)
Item Ports, panels, or slots
7 PCIe expansion card riser
4 (slot 7 and slot 8)
8 Power supply unit (PSU
2)
9
VGA port
10 USB 3.0 port (1)
11 iDRAC dedicated port
12 System identification
button
13
OCP NIC port (optional)
14 NIC port (1,2)
15 Power supply unit (PSU 1)
For more information about the ports, see the
Icon Description
N/A The expansion card riser enables you to connect PCI Express
expansion cards. For more information on the expansion cards that
are supported on your system, see
poweredgemanuals
For more information about the PSU configurations, see the
www.dell.com/poweredgemanuals
Enables you to connect a display device to the system. For more
information, see the
This port is USB 3.0-compliant.
Enables you to remotely access iDRAC. For more information, see
the iDRAC User's Guide at
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
● If the system stops responding during POST, press and hold
N/A This port supports OCP 3.0. The NIC ports are integrated on the
OCP card which is connected to the system board.
The NIC ports are embedded on the LOM card that is connected to
the system board.
For more information about the PSU configurations, see the
www.dell.com/poweredgemanuals
www.dell.com/poweredgemanuals
section.
www.dell.com/poweredgemanuals
www.dell.com/poweredgemanuals
button is enabled in the iDRAC setup.
the system ID button (for more than 5 seconds) to enter
the BIOS progress mode.
section.
www.dell.com/
section.
section.
section.
System overview 15