Dell EMC PowerEdge R7525 Installation And Service Manual page 159

Figure 142. System board screw location
Next steps
1. Replace the following components:
a. Trusted Platform Module
NOTE: The TPM Module must be replaced only while installing new system board.
b. IDSDM module (if
c. Internal USB card (if
d. Power supply units
e. OCP card (if installed).
f. Processor.
g. Heat sink.
h. Memory modules.
i. Cooling fan cage assembly.
j. Air shroud (if installed).
k. Rear drive cage.
2. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
feature section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the
update the Service Tag by using System Setup
(TPM).
installed).
installed).
(PSU).
Restoring the system by using the Easy Restore
section.
Installing and removing system components
Manually
159