Installing The Rear Mounting Front Perc Module - Dell EMC PowerEdge R7525 Installation And Service Manual

Figure 68. Removing the rear mounting front PERC module
Next steps
1. Replace the rear mounting front PERC

Installing the rear mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the backplane
4. If installed, remove the air
5. Remove the drive backplane.
6. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the connectors and guide slots on the front PERC module with the connectors and guide pins on the drive backplane.
2. Slide the front PERC module until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
module.
Safety instructions
Before working inside your system
cover.
shroud.
on page 26.
on page 27.
Installing and removing system components 69