Installing The Internal Usb Card - Dell EMC PowerEdge R7525 Installation And Service Manual

Figure 128. Removing the internal USB card
Next steps
1. Replace the internal USB

Installing the internal USB card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the expansion card
Steps
1. Connect the USB key to the internal USB card.
NOTE: Ensure to install the internal USB card in the IDSDM/USB card slot and not in the J_R3_PCIE_PWR connector
slot.
2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
card.
Safety instructions
Before working inside your system
risers.
on page 26.
on page 27.
Installing and removing system components 145