Dell EMC PowerEdge R7525 Installation And Service Manual page 143

to the manufacturer's instructions. See the Safety instructions. that came with your system for more
information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the power or data cables from the expansion cards.
4. Remove the expansion card
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
Figure 126. Removing the system battery
2. To install a new system battery:
a. Hold the battery with the positive side facing up and slide it under the securing tabs.
b. Press the battery into the connector until it snaps into place.
Safety instructions
Before working inside your system
risers.
on page 26.
on page 27.
Installing and removing system components 143