Installing The Side Wall Bracket - Dell EMC PowerEdge R7525 Installation And Service Manual

Figure 38. Removing the side wall bracket
Next steps
1. Replace the side wall

Installing the side wall bracket

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed, remove the front
4. Remove the backplane
5. If installed, remove the air
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the side wall bracket with the tabs on the chassis.
2. Press the side wall bracket with your thumbs until the bracket firmly clicks into place.
NOTE: Route the cables through the side wall bracket.
3. Close the side wall bracket cover with your thumbs until the cover firmly clicks into place.
48 Installing and removing system components
bracket.
Safety instructions
Before working inside your system
bezel.
cover.
shroud.
on page 26.
on page 27.