Optional Ocp Card; Removing The Ocp Card - Dell EMC PowerEdge R7525 Installation And Service Manual

Figure 131. Installing the intrusion switch module
Next steps
1. Install the expansion card
2. Follow the procedure listed in

Optional OCP card

Removing the OCP card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card
Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
148 Installing and removing system components
riser.
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 27.
on page 26.
on page 27.