Dell EMC PowerEdge R7525 Installation And Service Manual page 168

b. Twist the cable to 180 degrees to connect the MB_SL3 and MB_SL4 to the J_SL3 and J_SL4 connectors on the system
board.
c. Install the cable tie and tighten to fix the cables.
d. To know the XGMI cable connectors on the system board, refer to the
8. Install the full length expansion card riser
GPU risers.
9. Install the GPU air shroud top
10. Install the foam on the system cover. To install the foam,
a. Place the system cover with the System Information Lable (SIL) side facing up.
b. For easier handling, peel off a small section of the adhesive cover and align the foam with the system cover.
c. Remove rest of the adhesive cover, and install foam on the system cover.
d. Press along the length of the foam to ensure that it is firmly affixed to the system cover.
Figure 147. Installing Mylar foam on the system cover
After installing, follow the
168 Upgrade Kits
or half height expansion card
cover.
after working inside the system
System board jumpers and connectors
riser. See GPU kit components table for supported
instructions.
topic.