Dell EMC PowerEdge R7525 Installation And Service Manual page 167

NOTE: All GPU/FPGA cards require L-type heat sink and GPU shroud, irrespective of the length.
3. Remove the air shroud
4. Remove the GPU air shroud top
NOTE: The GPU air shroud top cover is part of the GPU air shroud.
5. Install the GPU.
Refer to the riser and GPU slot configuration table to know about the slots for the GPU installation.
Table 34. Riser and GPU slot configuration
Riser Riser slots
Riser 1 Slot 1
Slot 2
Riser 2 Slot 3
Slot 6
Riser 3 Slot 5
Riser 4 Slot 7
Slot 8
FH - Full Height, FL - Full Length, HH - Half Height, HL - Half Length
NOTE: For information on riser slot location on the system board, see the
6. If applicable, connect the power cables to the GPU. To know the connectors for GPU on the system board, see the
board jumpers and connectors
Refer to the GPU power cable matrix to know about the requirement of cable for the GPU.
Table 35. GPU power cable matrix
Category Description
GPU CRD,GRPHC,NVIDIA,
T4,16GB,70W,L
GPU CRD,GRPHC,32GB,2
25W,M10,PASSIV
GPU CRD,GRPHC,16GB,2
50W,V100,FF3.0
GPU CRD,GRPHC,32GB,2
50W,V100S,PCIE
GPU CRD,GRPHC,NVIDIA,
24GB,RTX6000
GPU CRD,GRPHC,NVIDIA,
48GB,RTX8000
FPGA Xilinx Snow White
Card
HH - Half Height, HL - Half Length, FH - Full Height, FL - Full Length
NOTE: Maximum of three full length GPUs with power cables or a maximum of six half lengths GPUs are supported in a
system.
7. To connect the XGMI cable,
a. Connect the MB_SL1 and MB_SL2 connectors on the XGMI cable to the J_SL1 and J_SL2 connectors on the system
board.
and install the GPU air shroud.
cover.
Processor
Processor 1
Processor 1
Processor 1
Processor 2
Processor 2
Processor 2
topic.
Type
HH and HL
FH and FL
FH and FL
FH and FL
FH and FL
FH and FL
FH and FL
System riser
configuration
Configuration 3
Configuration 6
Configuration 3 or 6
Configuration 3
Configuration 6
Configuration 3
Configuration 6
Vendor
NVIDIA
NVIDIA
NVIDIA
NVIDIA
NVIDIA
NVIDIA
Xilinx
Riser/card type
R1A - FH/FL or HL
R1C - FH/HL
R2A - HH/HL
R3A - FH/FL or HL
R3A - FH/HL
R4A - FH/FL or HL
R4C - FH/HL
System board jumpers and connectors
Cable Cable quantity
Not required Not required
6 + 2 pin cable 1 piece per GPU riser
8 pin cable 1 piece per GPU riser
8 pin cable 1 piece per GPU riser
8 pin cable 1 piece per GPU riser
8 pin cable 1 piece per GPU riser
6 + 2 pin cable 1 piece per GPU riser
GPU slots
2
1, 2
3, 6
5
7
7, 8
topic.
System
Upgrade Kits 167