Figure 37. Installing a cooling fan
Next steps
1. If removed,
install the air
2. Follow the procedure listed in
Side wall bracket
Removing the side wall bracket
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the front
4.
Remove the backplane
5. If installed,
remove the air
6.
Remove the cooling fan
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Press the tab to release the side wall bracket cover.
NOTE:
Unroute the cables to release them from the side wall bracket.
2. Release the bracket from the chassis, and lift it away from the system.
shroud.
After working inside your system
Safety instructions
Before working inside your system
bezel.
cover.
shroud.
assembly.
on page 27.
on page 26.
on page 27.
Installing and removing system components
47