Removing The Full Length Expansion Card Risers - Dell EMC PowerEdge R7525 Installation And Service Manual

Removing the full length expansion card risers

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the GPU air shroud top
Steps
1. To remove expansion card Riser 1A:
a. Loosen the captive screws on the riser.
b. Press the blue release tab and holding the edges lift the expansion card riser from the riser connector on the system
board.
c. Disconnect the GPU power cable from the system board.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 94. Removing the expansion card riser (Riser 1A)
2. To remove expansion card Riser 3A:
a. Press the blue button on the riser, and holding the touch points lift the expansion card riser from the riser connector on
the system board.
b. Disconnect the GPU power cable from the system board.
Safety instructions
Before working inside your system
cover.
on page 26.
on page 27.
Installing and removing system components 119