Mitsubishi L Series User Manual page 61

(b) Switching the mode by the dedicated instruction (G(P).OFFGAN)
This program performs the followings:
• first, switches the mode to the offset/gain setting mode by the dedicated instruction (G(P).OFFGAN),
• second, switches the channels for which the offset/gain settings is configured,
• third, writes the offset/gain value to the A/D converter module,
• finally, switches the mode back to the normal modes.
Switches to the offset/gain setting mode.
Sets a channel after offset/gain setting.
Sets a channel to the offset setting.
Sets a channel to the gain setting.
Switches the channel to offset/gain setting.
Registers the result of offset/gain setting to the module.
Switches to the normal mode.
The program enclosed by the doted line is the common programs among the following three programs.
• Switching the mode by the dedicated instruction (G(P).OFFGAN)
• Switching the mode by setting Mode switching setting (Un\G158, Un\G159) and by Operating condition setting
request (Y9)
• Switching the mode by the intelligent function module switch setting
CHAPTER 7 VARIOUS SETTINGS
Stores the setting data of the
dedicated instruction
(G.OFFGAN) in D1.
Dedicated instruction
(G.OFFGAN)
Stores the target channel
number in D0.
Specifies the offset target
channel.
Sets "0" for the gain target
channel.
Specifies the gain target
channel.
Sets "0" for the offset target
channel.
Turns on Channel change
request (Y3B).
Turns off Channel change
request (Y3B).
Turns on User range write
request (Y3A).
Turns off User range write
request (Y3A).
Stores the setting data of the
dedicated instruction
(G.OFFGAN) in D1.
Dedicated instruction
(G.OFFGAN)
Processing in normal mode
7
59