Mitsubishi L Series User Manual page 179

(8) Offset/gain setting mode Offset specification (Un\G22), Offset/gain setting
mode Gain specification (Un\G23)
Specify the channel to perform the offset/gain setting adjustment.
Offset/gain setting mode Offset specification (Un\G22): channel to adjust the offset
Offset/gain setting mode Gain specification (Un\G23): channel to adjust the gain
Offset/gain setting mode Offset specification (Un\G22)
Offset/gain setting mode Gain specification (Un\G23)
● The settings for multiple channels can be configured at the same time. However, set either of Offset/gain setting mode
Offset specification (Un\G22) or Offset/gain setting mode Gain specification (Un\G23) to be disabled (0).
When the settings for both of them are configured at the same time, a gain setting mode error (error code: 500) occurs.
● For details on offset/gain setting, refer to the following.
• Offset/gain setting (
(9) Averaging process setting (Un\G24)
Configure the setting when selecting sampling or averaging processing for each channel.
Averaging processing includes time average, count average and moving average.
b15
Processing method
Sampling processing
(a) Enabling the setting
Turn OFF → ON → OFF Operating condition setting request (Y9) to enable the setting.
(b) Default value
All channels are set to sampling (0) as the default value.
● When using Averaging process setting (used to replace Q64AD) (Un\G9), the value set in Averaging process setting
(Un\G24) is ignored. (The operation is performed in the averaging process setting in Averaging process setting (used to
replace Q64AD) (Un\G9).)
● The channel to which a value out of the above setting range is written performs the operation in the sampling processing.
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5
0 0 0
0 0 0
Page 54, Section 7.5)
to b12 b11 to b8 b7
CH4 CH3
Time average
Count average
Moving average
0 0 0 0 0 0
0 0 0 0 0 0
Data for b4 to b15 are fixed to "0".
to b4 b3 to
CH2 CH1
Setting value
APPENDICES
b4 b3 b2 b1 b0
0 0 0 CH4 CH3 CH2 CH1
0 0 0 CH4 CH3 CH2 CH1
1: Setting-target channel
0: Invalid
b0
0
H
1
H
2
H
3
H
177
A