Mitsubishi L Series User Manual page 138

(7) Shifting amount to conversion value
Set the shifting amount to conversion value in the "SHIFT" screen.
"SHIFT" screen
Input item lists
The "Shifting amount to conversion value" is reflected to the scaling value regardless of turning Operating condition setting
request (Y9) OFF → ON → OFF. However, when the "Shifting amount to conversion value" is set in a display unit, it is not
reflected just after setting. As well as other functions of display unit, turn the CPU module STOP → RUN → STOP → RUN to
reflect the setting value.
(8) Digital clipping enable/disable setting
Select "DISABLE" or "ENABLE" in the "DIGITALCLIP" screen.
"DIGITALCLIP" screen
(9) Input signal error detection extension setting
Select a detection method in the "INPUT SIG ENH" screen.
"INPUT SIG ENH" screen
When "INPUT SIG ENH" is set to other than "DISABLE", setting "INPUT SIG ERR" to "ENABLE" is not necessary.
The setting of "INPUT SIG ERR" will be ignored.
136
Input item
SHIFT
1.
Move the cursor using the
increment or decrement the value at the cursor, using
the and buttons, respectively. Confirm with the
button.
OK
Input range
Input upper limit
32767
1.
Use the and
"ENABLE", and then confirm with the
1.
Use the and
"ENABLE" from the following detection methods,
and then confirm with the
• DISABLE
• UPR/LWR
• LWR
• UPR
• DISCONNECT
and buttons, then
Input lower limit
-32768
buttons to select "DISABLE" or
button.
OK
buttons to select "DISABLE" or
button.
OK