Mitsubishi L Series User Manual page 181

(12)Digital clipping enable/disable setting (Un\G29)
Set whether the digital clipping function is enabled or disabled, for each channel.
For details on the digital clipping function, refer to the following.
• Digital Clipping Function (
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5
0 0
(a) Enabling the setting
Turn OFF → ON → OFF Operating condition setting request (Y9) to enable the setting.
(b) Default value
All channels are set to Disable (1).
(13)CH Maximum value (Un\G30, Un\G32, Un\G34, Un\G36), CH
(Un\G31, Un\G33, Un\G35, Un\G37)
The maximum and minimum values of converted digital output value are stored as signed 16-bit binary.
In the following cases, CH
(Un\G31, Un\G33, Un\G35, Un\G37) are updated with the current value.
• When turning OFF → ON → OFF Operating condition setting request (Y9) changes the setting
• When Maximum value/minimum value reset request (YD) is turned OFF → ON → OFF
● For the channel to which the averaging processing is specified, the maximum and minimum values are stored at
averaging processing time intervals.
● In CH
Maximum value (Un\G30, Un\G32, Un\G34, Un\G36) and CH
Un\G37), the values calculated by each function is stored using the following functions:
• Digital clipping function
• Scaling function
• Shift function
• Difference conversion function
(14)Input signal error detection setting (Un\G47)
Set whether the alarm output of input signal error detection is enabled or disabled for each channel. Only the
lower upper limit detection can be used as the detection method of an input signal error in this area.
• Input Signal Error Detection Function (
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5
0 0
(a) Enabling the setting
Turn OFF → ON → OFF Operating condition setting request (Y9) to enable the setting.
Page 90, Section 8.12)
0 0 0 0 0 0 0
Data for b4 to b15 are fixed to "0".
Maximum value (Un\G30, Un\G32, Un\G34, Un\G36) and CH
Page 69, Section 8.7)
0 0 0 0 0 0 0
Data for b4 to b15 are fixed to "0".
b4 b3 b2 b1 b0
0 0 0 CH4 CH3 CH2 CH1
0: Enabled
1: Disabled
Minimum value (Un\G31, Un\G33, Un\G35,
b4 b3 b2 b1 b0
0 0 0 CH4 CH3 CH2 CH1
0: Enabled
1: Disabled
APPENDICES
Minimum value
Minimum value
179
A