Mitsubishi L Series User Manual page 134

(2) A/D conversion enable/disable setting
Select "ENABLE" or "DISABLE" in the "A/D CONVERSION" screen.
"A/D CONVERSION" screen
(3) Averaging process setting
In the "AVE PROCESSING" screen, select whether to perform sampling processing or averaging processing
(time average, count average, moving average).
"AVE PROCESSING" screen
"TIME/COUNT/MOV" screen
Table of input items
Input item
TIME
COUNT
MOV
The display unit allows you to input between 2 to 62500 for any type of averaging processing, however, if the value is outside
the setting range of the averaging processing that you selected, an error will occur on the A/D converter module side.
132
↓
Conversion speed
20µs
80µs/1ms
20µs/80µs/1ms
20µs/80µs/1ms
1.
Use the and buttons to select "ENABLE" or
"DISABLE", and then confirm with the
1.
Use the and buttons to select "SAMPLING",
"TIME AVERAGE", "COUNT AVERAGE", or "MOVING
AVERAGE", and then confirm with the
selected any item other than "SAMPLING", proceed
to step 2.)
2.
Move the cursor using the
increment or decrement the value at the cursor, using
the and buttons, respectively. Confirm with the
button.
OK
Input range
Input upper limit
1500
5000
62500
1000
button.
OK
. (If you
OK
and buttons, then
Input lower limit
2
2
4
2