Mitsubishi L Series User Manual page 105

8.
When other than "0: Disable" in "Level trigger condition setting" is selected, set the stop condition
of logging with "Trigger data" and "Trigger setting value".
Item
Trigger data
Set the buffer memory address monitored as a occurrence condition to stop logging.
Trigger setting value Set the value of the buffer memory to stop logging.
*1 By setting Level data
a trigger data.
For details on the Level data, refer to the following.
• Level data (
● While "Conversion speed" is set as 20µs (0), setting CH
Enable causes an error.
● When the input signal error detection function and the input signal error detection extension function are set, setting CH
Logging enable/disable setting (Un\G1000 to Un\G1003) to Enable (0) causes an error.
● If the logging cycle setting value and the logging cycle set in the logging cycle input setting are below the digital output
value and the cycle of updating the scaling value (digital operation value), an error occurs and logging cannot be
performed.
● When the logging function turns disabled
The logging function turns disabled when any of the following error occurs after the logging function is enabled and
Operating condition setting request (Y9) is turned OFF → ON → OFF.
• Error code (20 ): Setting error of CH
• Error code (30 ): Setting error of CH
• Error code (31 ): Setting error of CH
• Error code (360): Setting error of Conversion speed setting (Un\G26)
• Error code (200
(Un\G1072 to Un\G1081) as a monitoring target, a device value of a CPU module can be set as
Page 194, Appendix 2(38))
Time Average/ Count Average/Moving Average (Un\G1 to Un\G4)
Time Average/ Count Average/Moving Average (Un\G1 to Un\G4)
Time Average/ Count Average/Moving Average (Un\G1 to Un\G4)
to 208 ): Setting error of a parameter setting item of the logging function
Description
Logging enable/disable setting (Un\G1000 to Un\G1003) to 0:
CHAPTER 8 FUNCTIONS
*1
103
8