Single Rs-232 Cable; Figure 4-18: Sata Drive Cable Connection - IEI Technology WAFER-CV-D25501 Series User Manual

WAFER-CV-D25501/N26001 3.5" SBC
Step 1: Locate the SATA connector and the SATA power connector. The locations of
the connectors are shown in Chapter 3.
Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector and the SATA power connector. See Figure 4-18.

Figure 4-18: SATA Drive Cable Connection

Step 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-18.
Step 4: To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.

4.6.6 Single RS-232 Cable

The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
Page 57