Chassis Installation; Airflow; Motherboard Installation; Internal Peripheral Device Connections - IEI Technology WSB-PV-D4251 User Manual

Figure 4-6: LCD Voltage Select Jumper Location

4.6 Chassis Installation

4.6.1 Airflow

WARNING:
Airflow is critical for keeping components within recommended
operating temperatures. The chassis should have fans and vents as
necessary to keep things cool.
The WSB-PV-D4251/D5251 must be installed in a chassis with ventilation holes on the
sides allowing airflow to travel through the heat sink surface. In a system with an individual
power supply unit, the cooling fan of a power supply can also help generate airflow
through the board surface.

4.6.2 Motherboard Installation

To install the WSB-PV-D4251/D5251 motherboard into the chassis please refer to the
reference material that came with the chassis.

4.7 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the onboard connectors.

4.7.1 Dual RS-232 Cable with Slot Bracket

The dual RS-232 cable slot connector consists of two connectors attached to two
independent cables. Each cable is then attached to a D-sub 9 male connector that is
mounted onto a slot. To install the dual RS-232 cable, please follow the steps below.
Page 44
WSB-PV-D4251/D5251 SBC