Single Rs-232 Cable (W/O Bracket); Figure 4-13: Sata Drive Cable Connection - IEI Technology NANO-QM770-R10 User Manual

NANO-QM770 EPIC SBC

Figure 4-13: SATA Drive Cable Connection

Step 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-13.
Step 4: To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.

4.7.4 Single RS-232 Cable (w/o Bracket)

The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
Step 1: Locate the connector. The location of the RS-232 connector is shown in
Chapter 3.
Step 2: Insert the cable connector. Insert the connector into the serial port pin header.
See Figure 4-14. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Step 0:
Page 55