PM-PV-N4551/D5251 User Manual
4.8.4 USB Cable
The PM-PV-N4551/D5251 is shipped with a dual port USB 2.0 cable. To connect the USB
cable connector, please follow the steps below.
Step 1:
Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2:
Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the PM-PV-N4551/D5251 USB connector.
Step 3:
Insert the cable connectors. Once the cable connectors are properly aligned
with the USB connectors on the PM-PV-N4551/D5251, connect the cable
connectors to the on-board connectors. See Figure 4-14.
Figure 4-14: Dual USB Cable Connection
Step 4:
Attach the USB connectors to the chassis. The USB 2.0 connectors each of
two retention screw holes. To secure the connectors to the chassis please refer
to the installation instructions that came with the
chassis.Step 0:
Page 53