Table of Contents
Advertisement
BChecking V-belt
To avoid personal injury or death:
A Stop the engine and remove the key before
checking the V-belt.
A Check the V-belt for cracks and proper tension.
(See "Adjusting V-belt Tension" in "REGULAR
CHECKS
AND
section.)
BWashing Whole Machine
A Do not wash the machine with the engine running.
Water could enter the air cleaner and damage the
engine.
Make sure that the air cleaner is kept dry.
A Remove the mud before washing the machine.
BChecking Machine Side and Rear Grills
Check if the machine side and rear grills are clogged. If so
clean with compressed air or steam.
(1) Side grills (LH and RH)
(2) Side grill (RH only)
MAINTENANCE
WORK"
(1) Rear grills
A If the machine is operated with clogged grills, the
temperature in the machine becomes higher. That will
shorten the service life of the machine parts.
BDraining Water Separator
[Checking and Draining]
Water and dirt contained in fuel will settle down in the
water separator. When such foreign substances are
deposited, set the shutoff-valve to the "CLOSE" position.
Loosen the top screw first and then the bottom drain plug
to let the foreign substances out of the separator.
Finally be sure to air-bleed the fuel system.
[Cleaning]
1. Set the shutoff-valve to the "CLOSE" position.
2. Loosen and remove the cup, then clean the inside
surface with light oil.
3. Tighten up the cup.
(1) Screw
(4) Float
(2) Cup
(5) Drain plug
(3) Shutoff-valve
(6) Connector of
water level sensor
MAINTENANCE
59
(A) "CLOSE"
(B) "OPEN"
(C) Loosen
(D) Tighten
Advertisement
Table of Contents
