Checking, Disassembling And Servicing; Checking And Adjusting; Engine Body - Kubota RTV1140CPX Workshop Manual

RTV1140CPX, WSM

4. CHECKING, DISASSEMBLING AND SERVICING

[1] CHECKING AND ADJUSTING

(1) Engine Body

Compression Pressure
1. Run the engine until it is warmed up.
2. Stop the engine.
3. Remove the air cleaner, the muffler and all glow plugs (or
nozzles).
4. Set a compression tester with the adaptor to the glow plug hole
(or nozzle hole).
Nozzle hole: Adaptor H (07909-31231)
Glow plug hole: Adaptor L (07909-31301)
5. After making sure that the stop lever is set at the stop position
(non-injection), run the engine with the starter and measure the
compression pressure.
6. Repeat steps 4 and 5 for each cylinder.
7. If the measurement is below the allowable limit, apply a small
amount of oil to the cylinder wall through the glow plug hole (or
nozzle hole) and measure the compression pressure again.
8. If the compression pressure is still less than the allowable limit,
check the top clearance, valve clearance and cylinder head.
9. If the compression pressure increases after applying oil, check
the cylinder wall and piston rings.
NOTE
• Check the compression pressure with the specified valve
clearance.
• Always use a fully charged battery for performing this test.
• Variances in cylinder compression values should be under
10 %.
Factory specification
Compression pressure
Allowable limit
1-S10
ENGINE
3.14 to 3.53 MPa
2
32.0 to 36.0 kgf/cm
456 to 512 psi
2.26 MPa
2
23.0 kgf/cm
327 psi
9Y1210293ENS0008US0
KiSC issued 05, 2014 A