Spin Turn; Operation Of The Lift Arms; Operation Of The Bucket - Kubota SSV65 Operator's Manual

34 OPERATION OF THE MACHINE
BSpin Turn
C To spin left:
Tilt the left control (traveling) lever to the left.
C To spin right:
Tilt the left control (traveling) lever to the right.
(1) Left control (traveling) lever (A) Spin left

OPERATION OF THE LIFT ARMS

C To lower the lift arms:
Push the right control (front operating) lever forward:
C To raise the lift arms :
Pull the right control (front operating) lever backward.
(1) Right control (front operating) lever
A To stop the lift arm operation, return the right control
(front operating) lever to the neutral position.
(B) Spin right
(A) "LOWER"
(B) "RAISE"
To avoid personal injury or death:
A Do not exceed the rated operating capacity of
the unit. If loads exceed this operating
capacity, the unit can experience a hydraulic
imbalance when half or medium "lift arms
raise" and "bucket roll back" or "auxiliary
hydraulic control"
together, which can result in the lift arms
lowering slowly. If you begin to experience this
condition, either place the lift arms control in
"neutral" or input full "raise" control, and lift
arms lowering will cease.

OPERATION OF THE BUCKET

C To roll bucket back:
Tilt the right control (front operating) lever to the left.
C To dump bucket:
Tilt the right control (front operating) lever to the right.
(1) Right control (front operating) lever
A To stop the bucket operation, return the right control
(front operating) lever to the neutral position.
To avoid personal injury or death:
A Do not exceed the rated operating capacity of
the unit. If loads exceed this operating
capacity, the unit can experience a hydraulic
imbalance when half or medium "lift arms
raise" and "bucket roll back" or "auxiliary
hydraulic control"
together, which can result in the lift arms
lowering slowly. If you begin to experience this
condition, either place the lift arms control in
"neutral" or input full "raise" control, and lift
arms lowering will cease.
commands are input
(A) "ROLL BACK"
(B) "DUMP"
commands are input