Checking The Safety Devices; Emergency Exit; Armrests Function; Opc Function - Kubota SSV65 Operator's Manual

CHECKING THE SAFETY DEVICES

To avoid personal injury or death:
A Place the machine on a firm, flat and level
surface.
A Before starting the engine, make sure that no
one is near the machine.
BEmergency Exit
If you should become trapped in the cab, you can open
the rear window to get out.
1. This window is equipped with latches.
2. Turn both latches clockwise until they disengage from
the window frame.
3. Push the rear window out of the rear of the operator
cab.
4. Exit through the rear of the operator cab.
(1) Window
(2) Latch
BArmrests Function
1. Sit in the operator's seat.
2. Fasten the seat belt.
3. Start the engine.
4. Push down both armrests.
5. Push on the hydraulic unlock switch and make sure
that the hydraulic lock lamp on the instrument panel
goes out.
6. Move the right control (front operating) lever slowly
and make sure that the lift arms and bucket move
slowly.
7. Raise the left armrest. Make sure that the hydraulic
lock lamp on the instrument panel lights up.
8. Move the right control (front operating) lever and make
sure that the lift arms and bucket do not get activated.
9. Push down the left armrest.
10. Push on the hydraulic unlock switch and make sure
that the hydraulic lock lamp on the instrument panel
goes out.
CHECKS BEFORE START
11. Raise the right armrest. Make sure that the hydraulic
lock lamp on the instrument panel lights up.
12. Move the right control (front operating) lever and make
sure that the lift arms and bucket do not get activated.
BOPC Function
To avoid personal injury or death :
A While checking the OPC function, you start the
engine without wearing the seat belt. After
making sure that the OPC function gets
activated as specified, be sure to fasten the
seat belt and operate the machine.
Make sure that the armrests function as specified, and
then check the OPC function.
1. Sit in the operator's seat.
2. Start the engine.
3. Push down both the armrests.
4. Push on the hydraulic unlock switch and make sure
that the hydraulic lock lamp on the instrument panel
goes out.
5. With the armrests kept down, get off the operator's
seat and make sure that the hydraulic lock lamp on the
instrument panel lights up in 3 seconds. During this
action, be careful not to touch the control lever and the
foot pedal.
BForced Lift Arms Lowering Device
1. Start the engine.
2. Move the right control (front operating) lever until the
lift arms come up to your eye level.
3. Stop the engine.
4. Slide the operator's seat all the way backward.
5. Remove the rubber cap.
6. Push the lever to make sure that the lift arms descend.
7. Release the lever to make sure that the lift arms stop
descending.
8. Replace the rubber cap back in its original position.
(1) Rubber cap
(2) Lever
21
(A) "PUSH"