Checking Parking Brake; Checking Gauges, Meter And Easy Checker; Checking Head Lights, Tail Lights And Other Lights (If Equipped); Checking Seat Belt And Rops - Kubota RTV520 Operator's Manual

DAILY CHECK

10. Checking parking brake

Pull the parking brake lever to apply the brakes. With
the key switch at "ON" position, the brake indicator on
the instrument panel lights up.
To release the brakes, push in the button at the tip of
the parking brake lever and tilt down the lever.
NOTE :
• Make sure the parking brake indicator light
on the Easy Checker
brake lever is down.
(1) Parking brake lever
(2) Release button
11. Checking gauges, meter and
™
Easy Checker
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker
2. Replace if broken.
12. Checking head lights, tail lights
and other lights (if equipped)
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.

13. Checking seat belt and ROPS

1. Always check condition of seat belt and ROPS
attaching hardware before operating vehicle.
2. Replace if damaged.

14. Checking joint boots

1. Check to see if the joint boots are damaged.
2. If the joint boots are damaged, cracked or show
signs of deterioration, consult your local KUBOTA
Dealer.
RTV520
™
goes off when parking
(A) "PULL"
(B) "RELEASE"
™
lamps.
(1) Joint boot
(2) Front drive shaft
(3) Tie rod
(1) Joint boot
(2) Drive shaft

15. Checking tire inflation pressure

Though the tire pressure is factory-set to the prescribed
level, it naturally drops slowly in the course of time.
Thus, check it everyday and inflate as necessary.
Tire sizes
24 × 9 - 12 HDWS, Front
24 × 11 - 12 HDWS, Rear
24 × 9 - 12 ATV, Front
24 × 11 - 12 ATV, Rear
PERIODIC SERVICE
Inflation pressure
97 kPa
2
(0.99 kgf/cm , 14 psi)
59