Tilting Up The Cab - Kubota SSV65 Operator's Manual

A Before putting the jack stands, adjust them to the
same height.
BTilting Up the CAB
For inspection and maintenance, the CAB is designed so
that it can be tilted up.
To avoid personal injury or death:
A Raising or lowering the cab while the engine is
running may cause the machine to move, and
cause personal injury or death. Place the
machine on a firm, flat and level surface, lower
the lift arms slowly to the ground and stop the
engine before raising or lowering the cab.
A When tilting up the CAB, use the stopper lock
not to be released the stopper suddenly.
A Do not enter beneath the cab, while raising or
lowering the cab.
A More than one person may be needed to tilt the
cab.
(A) Put the jack stands
(B) Put the garage jack
C Raising (Tilt up)
1. Select a firm, level surface, lower the lift arms fully to
the ground, and stop the engine.
If the lift arm must be up while raising the operator cab,
install the lift arm support device. (See "Lift Arm
Stopper" on Page 22.)
Put the jack stands under the rear corners of the
frame.
(1) Jack stands
2. Set the armrest to the "RAISED" position.
3. Remove the lock bolts from the front of the machine.
(1) Lock bolt
MAINTENANCE 53