Table of Contents
Advertisement
OTHER ADJUSTMENTS AND REPLACEMENTS
PURGING OF THE FUEL SYSTEM
1. Fill up the machine with fuel.
2. Turn the starter key to the "RUN" position.
3. The air in the fuel system will automatically be purged
within one minute.
(1) Starter switch
A If the purging was insufficient, the engine dies right
after starting. In this case repeat steps 2 to 3 again.
TIRES
BHandling Tires
To avoid personal injury or death:
A Before handling tires, stop the engine, set the
parking brake switch to the parking position,
lower the bucket and attachment to the ground,
release the hydraulic pressure in the hydraulic
system by operating control levers. Lock all
control levers in neutral, and remove the key.
A When raising the tire, block up the chassis for
safety.
A Before adding air, have the tire correctly
installed on the machine or put the tire in a
retaining device (tire inflation cage). Explosive
separation of the tire can cause serious injury.
(A) "STOP"
(B) "RUN"
(C) "START"
OTHER ADJUSTMENTS AND REPLACEMENTS
BChecking of Tires
See "Checking of Tires" in "DAILY CHECKS" in
"MAINTENANCE" section.
BChanging Tires
See "Changing Tires" in "EVERY 50 SERVICE HOURS"
in "REGULAR CHECKS AND MAINTENANCE WORK"
section.
BMounting Tires
See "Mounting Tires" in "EVERY 50 SERVICE HOURS"
in "REGULAR CHECKS AND MAINTENANCE WORK"
section.
FUSES
To avoid personal injury or death:
A When changing fuse, stop the engine and turn
the key in position "STOP". Keep the lock lever
for attachment control in the "LOCK" position.
BReplacing Fuses
1. Detach the cover and remove the cover of the fuse
box.
2. Replace the burnt out fuse with a fuse having the same
capacity.
(1) Cover
(2) Fuse box
81
Advertisement
Table of Contents
