Checking Brake Pedal; Checking Parking Brake; Checking Gauges, Meter And Easy Checker(Tm); Checking Head Light, Etc - Kubota RTV400 Operator's Manual

BChecking Brake Pedal
To avoid personal injury:
A Stop the engine and chock the wheels before

checking brake pedal.

1. Inspect the brake pedals for free travel, and smooth
operation.
2. Adjust if incorrect measurement is found: (See
"Checking Brake Pedal" in "EVERY 200 HOURS" in
"PERIODIC SERVICE" section.)
(1) Brake pedal (A) "FREE TRAVEL"
(B) "PEDAL STROKE"
BChecking Parking Brake
Pull the parking brake lever to apply the brakes. With the
key switch at "ON" position, the brake indicator on the
instrument panel lights up. To release the brakes, push in
the button at the tip of the parking brake lever and tilt down
the lever.
A Make sure the brake indicator light on the Easy
Checker(TM) goes off when parking brake lever is
down.
(1) Parking brake lever
(2) Release button
BChecking Gauges, Meter and Easy
Checker(TM)
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker(TM) lamps.
2. Replace if broken.
BChecking Head Light, etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
BChecking Seat Belt and ROPS
1. Always check condition of seat belt and ROPS
attaching hardware before operating vehicle.
2. Replace if damaged.
PERIODIC SERVICE
(A) "PULL"
(B) "RELEASE"
43