Table of Contents
Advertisement
BReplacing Water Separator Filter Element
1. Set the water shutoff-valve to the "CLOSE" position.
2. Loosen and remove the cup properly and replace the
filter element.
3. Check the condition of the O-ring and replace if
necessary.
4. Tighten up the cup properly.
5. Set the shutoff-valve to the "OPEN" position.
(1) Screw
(2) Cup
(3) Shutoff-valve
(4) Float
(5) Drain plug
(6) Connector of water level sensor
(7) Head cover
(8) Filter element
(9) O-ring
A In reattaching the water separator, be careful to keep
off dust and dirt.
A Be sure to purge the fuel system before getting the
machine restarted.
(See "PURGING OF THE FUEL SYSTEM" in
"OTHER
CHECKS
section.)
(A) "CLOSE"
(B) "OPEN"
(C) Loosen
(D) Tighten
AND
REPLACEMENTS"
REGULAR CHECKS AND MAINTENANCE WORK
EVERY 1000 SERVICE HOURS
Do all 50, 250 and 500 hour servicing at the same time.
BHydraulic Oil Change (Including
Replacing Suction Filter in the Hydraulic
Tank and Return Filter)
To avoid personal injury or death:
A Wait long enough for the hydraulic fluid to cool
down. Then change the hydraulic fluid.
A Before filling oil, wipe away all sand and dust from
around the oil port. Make sure to use an identical type
of hydraulic fluid.
A The machine has been filled with hydraulic fluid before
delivery. See "RECOMMENDED OILS" section.
(Do not mix different oils.)
1. Park the machine on a firm, flat and level surface.
Lower the lift arms to the ground and stop the engine.
75
Advertisement
Table of Contents
