Table of Contents
Advertisement
4. SAFE LOADING AND TRANSPORT OF
THE MACHINE
1. Observe all regulations concerning the transport of the
machine on public roads.
2. Use adequately long and robust ramps when loading
the machine. Block the ramps and transport
appropriately. If towing is required, use proper tow
lines and attachment points. (for details, see
"TRANSPORTING THE MACHINE" section)
3. To avoid tipping over, the heaviest end of the unit
should proceed up the ramps first, do not change the
running direction and do not swing the attachment
crosswise to the loading ramps.
4. Lower the attachment on the loading bed and release
the pressure from the hydraulic system. After loading
the machine on the truck, secure the tires with blocks
and tie down the machine at the appropriate locations.
(1) Chain
(2) Block
5. Avoid abrupt braking of the vehicle with the machine
loaded. Sudden braking could cause the machine to
move and could cause a serious accident.
5. MAINTENANCE
Before doing maintenance work on the machine, place
the machine on a firm, flat and level surface, lower the lift
arms slowly to the ground, stop the engine, remove the
key.
When dismantling hydraulic parts, make sure that the
hydraulic oil has cooled down sufficiently to avoid burns.
Start maintenance work carefully, e.g. loosen the plug
slowly so that oil will not squirt out.
1. Before working on the engine, the exhaust system, the
radiator and the hydraulic system, let the machine cool
down sufficiently.
2. Turn off the engine at all times when filling with fuel.
Avoid spilling and over-filling of fuel.
3. Smoking is prohibited while refueling or handling the
battery. Keep sparks and fire away from the fuel tank
and battery. Flammable gases escape from the
battery, especially during charging.
4. Read and follow the directions "STARTING WITH AN
AUXILIARY BATTERY" in "OPERATION OF THE
ENGINE" section, when starting with an auxiliary
battery.
5. Keep a first-aid box and extinguisher at hand at all
times.
6. Do not open the radiator cap before the radiator has
cooled down sufficiently. First loosen the cap to the
first stop and allow the system enough time to release
the remaining pressure. Then loosen the cap
completely.
7. Failure to follow proper procedures when mounting a
tire on a wheel or rim can produce an explosion which
may result in serious injury or death. Do not attempt to
mount a tire unless you have the proper equipment
and experience to perform the job. When inflating the
tire, use a self-holding chuck and a remotely-operable
shut valve as well. Keep blowing up the tire away from
it. Have it done by your KUBOTA dealer or a qualified
tire repair service.
SAFE OPERATION
5
-
Advertisement
Table of Contents
