Kubota SSV65 Operator's Manual page 11

SAFE OPERATION
Careful operation is your best insurance against an
accident.
Read and understand this section carefully, before
operating the machine.
Every user, however experienced, should carefully read
and understand this section and those of the attachments
and accessories before taking the machine into operation.
The owner is obliged to inform the operators of these
instructions in detail.
Keep this manual in the storage place. (See "Where to
keep Operator's Manual" in "MAINTENANCE" section.)
1. BEFORE OPERATION
1. Know your equipment and its limitations. Read and
understand this entire manual before attempting to
start and operate the machine.
2. Obey the danger, warning and caution labels on the
machine.
3. For your safety, a ROPS/FOPS (Roll-Over Protective
Structure/Falling Objects Protective Structure) with a
seat belt is installed by KUBOTA. Always use the seat
belt when the machine is equipped with the ROPS/
FOPS as this combination will reduce the risk of
personal injury or death, should the machine be upset.
Do not modify structural members of ROPS by
welding, drilling, bending, grinding or cutting, as this
may weaken the structure. If any component is
damaged, replace it. Do not attempt repairs. If the
ROPS is loosened or removed for any reason, make
sure all parts are reinstalled correctly. Tighten
mounting bolts to proper torque.
4. The ROPS/FOPS structure complies with ISO 3471,
ISO 3449 and OSHA regulations.
5. The seat belt must be inspected regularly and
replaced if frayed or damaged.
6. Always sit in the operator's seat when starting the
engine or operating the levers or controls.
7. Do not operate the machine while under the influence
of alcohol, medication, controlled substances or while
fatigued.
8. Check the surrounding area carefully before using the
machine or when attachments are being connected.
To avoid any danger of electrocution, never operate
the machine near power lines before confirming the
power is off. Never approach a machine or load that is
contacting a power source such as power lines.
Electrocution can occur by coming into contact with a
machine that is near power lines.
9. Check for buried pipes and cables before digging.
10. Check for hidden holes, obstacles, soft underground,
and overhangs. Do not enter soft ground.
A During machine use, do not allow any persons
within the working range.
SAFE OPERATION 1
-