Table of Contents
Advertisement
22
CHECKS BEFORE START
BLift Arm Stopper
To avoid personal injury or death:
A Never work on a machine with the lift arms up
unless the lift arms are secured by an approved
lift arm stopper.
The lift arm stopper is used to prevent the lift arms from
falling when servicing the machine.
C Installing
1. Remove the front attachment.
2. Park the machine on level and firm ground and lower
the lift arms fully to the ground.
3. Stop the engine.
4. Put jack stands under the rear corners of the frame.
(1) Jack stands
5. The second person should remove the lift arm stopper
from the storage position.
(1) Lift arm stopper
(2) Knob bolt
6. Start the engine and set the parking brake switch to
the parked position.
7. Slowly raise the lift arms to the maximum height and
stop the engine.
Operator must stay in the operator seat with the seat
belt fastened.
8. The second person must install the lift arm stopper.
Place the top of lift arm stopper upward and cover the
rod with the stopper from rear.
(1) Lift arm stopper
9. Start the engine and set the parking brake switch to
the parking position.
10. Slowly lower the lift arms against the lift arm stopper.
A Make sure that the top of the lift arm stopper fits the flat
part of the lift arm and that the bottom of lift arm
stopper fits the flat top of arm cylinder rod. No gap is
allowed in both locations.
(1) Lift arm stopper
(2) Arm cylinder rod
(A) "FIT"
Advertisement
Table of Contents
