Checking Parking Brake; Checking Gauges, Meter And Easy Checker(Tm); Checking Head Light, Turn Signal Light Etc; Checking Seat Belt And Rops - Kubota RTV900 Operator's Manual

BChecking Parking Brake
Pull the parking brake lever to apply the brakes. With the
key switch at "ON" position, the parking brake indicator on
the instrument panel lights up. To release the brakes,
push in the button at the tip of the parking brake lever and
tilt down the lever.
A Make sure the parking brake warning lamp
Easy Checker(TM) goes off when parking brake lever
is down.
(1) Parking brake lever
(2) Release button
BChecking Gauges, Meter and Easy
Checker(TM)
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker(TM) lamps.
2. Replace if broken.
BChecking Head Light, Turn Signal Light
etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
BChecking Seat Belt and ROPS
1. Always check condition of seat belt and ROPS
attaching hardware before operating vehicle.
2. Replace if damaged.
on the
(A) "PULL"
(B) "RELEASE"
BChecking Joint Boot
1. Check to see if the joint boots are not damaged.
2. If the boots are cuts, cracked or shows signs of
deterioration, consult your local KUBOTA Dealer.
(1) Joint boot
(2) Front drive shaft
(3) Tie rod
(1) Joint boot
(2) Rear drive shaft
(1) Joint boot
(2) Drive shaft
PERIODIC SERVICE 53