Checks Before Start; Daily Checks; Checking The Switches; Hydraulic Unlock Switch - Kubota SSV65 Operator's Manual

8

CHECKS BEFORE START

CHECKS BEFORE START

DAILY CHECKS

In order to avoid damage, it is important to check the
condition of the machine before starting.
To avoid personal injury or death:
A Do maintenance work on the machine only on
level ground with the engine off and armrest in
the "Raised" position.
Checks
A Go around the machine and check for visual damage
and wear.
A Check coolant level. (See "DAILY CHECKS" in
"MAINTENANCE" section.)
A Check fuel level.
A Check engine oil level.
A Check hydraulic fluid level.
A Check air cleaner warning indicator. (See "DAILY
CHECKS" in "MAINTENANCE" section).
A Check all control lamps, indicators and hour meter.
A Check the seat belt and the ROPS/FOPS safety
device.
A Check Diesel Particulate Filter (DPF) muffler.
A Check the condition of the safety and warning labels.
(See "DANGER, WARNING AND CAUTION LABELS"
in "SAFE OPERATION" section.)

CHECKING THE SWITCHES

BHydraulic Unlock Switch
To avoid personal injury or death:
A Do not operate the left control (traveling) lever,
immediately after the hydraulic unlock switch
is unlocked.
Parking brake is still engaged for a short time.
The hydraulic unlock switch enables the hydraulic system.
The switch is intended to get the hydraulic system
(travelling and attachments) ready for use, but does not
have the locking function.
To unlock the hydraulic
requirements are needed:
(1) The engine is running.
(2) The armrests are down.
(3) The operator is seated on the operator's seat.
When the hydraulic system has been unlocked, the
hydraulic lock lamp on the instrument panel disappears.
If any of the above conditions is not met, the hydraulic
system stays locked.

(1) Hydraulic unlock switch

(2) Hydraulic lock lump
BOPC Switch
This switch is used to detect the operator sitting on the
seat and to signal the hydraulic system that it can be
locked and unlocked.
When the operator sits on the seat, the OPC switch is ON,
the hydraulic system can be unlocked.
When the hydraulic system is unlocked and the operator
leaves the seat for up to 3 seconds, the OPC switch turns
off. Now the hydraulic system is locked.
system, the following