General Settings - Siemens SINUMERIK 840D sl Commissioning Manual

Configuring tool management

13.10 General settings

13.10 General settings
The general settings for the tool management user interface are stored in the <SETTINGS>
tag.
Entries
ReactivateWithMagPos
ReactivateAllMonitorModes
ReactivateEnabled
MagazineMoveMessage
CreateNewToolDialog
MagazineSelectionDialog
NewToolFavoritesOnly
SortationInFirstEtcLevel
102
Meaning
Refers to the "Reactivate" function.
true - Reactivate a locked tool with positioning of the tool at the
magazine loading point.
false - Reactivate without positioning of the magazine.
Refers to the "Reactivate" function.
true – The actual values of all the monitoring types set in the NC are
reset.
false – The actual value of the monitoring type active on the tool is
reset.
Refers to the "Reactivate" function.
true - Reactivation is enabled.
false - Reactivation is disabled.
Refers to the message output while the magazine is moving.
true - "Magazine movement running" or "Magazine movement ended"
message is displayed.
false - Message is not displayed.
Refers to the "New tool" function.
true - The "New Tool" window appears. In this window, you can
specify the type of magazine location and the size of the tool before
actually creating the tool.
false - The "New Tool" window does not appear. Once the name has
been entered, the tool will be created directly in the tool list.
Refers to the "Magazine selection" function.
true - A dialog box displaying the buffer, magazine and NC memory
is displayed. A check mark can be added to or removed from each of
these elements to indicate whether that element appears in the list
display. The "Go to" softkey can be used to select an element directly
in the list display.
false - No dialog box for magazine selection. The system switches
between the buffer, the magazines and the NC memory.
If there is no MagazineSelectionDialog entry in the <Settings> tag,
the dialog box is automatically displayed with more than one
magazine (excluding the system magazine) when magazine
configuration is taking place. If there is only one magazine, the
switchover function is used.
Refers to the "New tool" function.
Only those tool types configured as favorites are offered.
Section 1.7
Refers to the "Sorting" function.
The Sorting function is placed in the first softkey level. The
"Continue" function is omitted.
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
HMI sl (IM9)